CopraSintec K

Soft as wax milling of Co/Cr – wet or dry! The isostatic high pressure manufacturing process allows bridges with up to 14 units and even implant bar restorations. Non precious metal alloy type 4, therefore no limitations compared to milled or cast Co/Cr alloys. The small shrinkage allows you to place up to 40 units in a blank. Minimal wear of burs.

 

The Facts

  • Optimal homogeneity due to isostatic high pressure manufacturing process allows bar restorations, bridges with up to 14 pontics and delicate elaboration in familiar, dental technical execution
  • Non precious metal alloy type 4, therefore no limitations compared to milled or cast Co/ Cr alloys
  • High yield due to big surface and small shrinkage – up to 40 units in a blank
  • Only 8,5% shrinkage due to unique, isostatic high pressure manufacturing process with optimal homogeneity – no distortion during sintering
  • Familiar blank height in 10mm/ 12mm/ 14mm/ 16mm/ 18mm und 20mm
  • Minimal wear of burs due to soft, but milling resistant material structure – therefore often called soft metal
  • Optional wet- or dry processing possible using a wax strategy

 

Note: On our round blanks you will already find the adequate shrinkage for Amann Girrbach* systems.

 

Blanks from 12 mm with Step Unit
CopraSintec K CoCr-Blank 98 Ø x 10 mm 1
CopraSintec K CoCr-Blank 98 Ø x 12 mm 1
CopraSintec K CoCr-Blank 98 Ø x 14 mm 1
CopraSintec K CoCr-Blank 98 Ø x 16 mm 1
CopraSintec K CoCr-Blank 98 Ø x 18 mm 1
CopraSintec K CoCr-Blank 98 Ø x 20 mm 1

CE 26 x 20 0483      FDA approved     IdentAlloy

The terms marked with * are registered trademarks and/or brand names of the respective companies.